SSD not seen in drive selection
What should I do if I don't see my SSD in Drive Selection?
1. Replace the SATA cable and try again.
2. Make sure that the SATA connector on the board does not contain any debris, or is not damaged.
3. When SSD is not properly connected, the system may fail to detect the SSD. Disconnect the cable and reconnect.
4. Connect the SSD to a different SATA Port and see if the drive is detected.
• Check to see if the SSD is connected to an expansion port. If it is, then connect the SSD to a regular port.
• If the SSD is connected to a regular port, switch to a different port and reboot.
5. If the SSD is properly connected but is not shown in the Drive Selection, try the following steps.
• Right-click the My Computer icon => Select Manage => Select Storage => Click Disk Management => Make sure that the disk is set up properly.
• Make sure that the disk is enabled and set as a Dynamic Disk. If it is not, change its setting to Dynamic Disk.
6. Connect the SSD to a different computer to check if there is a problem with the SSD itself.